Vinyl Application - Vinyl Accent Wall Lettering, Designs and Decals

First choose the desired location for your new wall lettering and accents. Dust and then clean the area thoroughly with a de-greaser (Windex works well) and make sure it is dry before you begin. The more your wall is free from dirt and grease the better the lettering will adhere. If you have recently painted, your paint must cure(dry) for at least 2 weeks. If you have a large piece, it is helpful to have 2 people to assist in holding and applying the vinyl.

Supplies:
- Applicator provided in your order
- Ruler
- Tape Measurer
- Level and/or Straightedge
- Masking Tape
- Pencil with eraser
- Time and patience

Your letters come pre-spaced and made up of 3 layers:
Top Layer - transfer tape
Middle layer - your vinyl lettering
Bottom Layer – white or blue backing paper

Steps:

Step 1:
Your lettering will arrive rolled up, unroll and lay on a flat surface. Now use your applicator we have provided for you to rub firmly over the surface of the top of your piece to make sure the lettering adheres to the transfer tape.

Step 2:
Choose your desired location and use your level to put 2 small reference marks on the wall at least 12 inches apart or as long as the width of the lettering allows. These reference marks will be used to align the top edge of your lettering strip. Tape may be used instead of pencil marks.

Step 3:
Now, align the top strip with your reference marks and use tape to place on the wall. This is what is called the hinge. After you have finished this step, it is a good time to step back and look at the placement to make sure it is where you want it. There is no changing your mind after the vinyl is on the wall or other surface!

Step 4:
Using the hinge you have created, swing the strip up and flat against the wall upside down with the backing facing you. Start at a corner and peel the backing off. (Remember not to touch the vinyl itself, as the oils from your fingers can damage the vinyl adhesive.) Do not pull the backing towards you, rather keep it at a tight bend towards itself and slide it downward. If you find a letter sticking to the backing, just slide the backing over it again and rub it against the transfer tape to release it to the transfer tape. If it is really stubborn, use an exacto knife to release from backing.

Step 5:
Once you have removed the backing, swing the lettering down so the adhesive side of the lettering is resting lightly on the wall. Press the lettering, starting in the center and moving outward. At this point you may use your fingers to press the lettering or use your applicator to make sure all the lettering is adhering to your surface.

Step 6:
Remove your masking hinge tape. Begin at a corner and pull the transfer tape in the same manner as the backing paper, tight against itself. Pulling out towards you could pull a letter with it. If a letter does not release from the transfer tape, just press the letter and tape back to the wall and rub again. It is important to keep the transfer tape tight against itself for the best release. Keep going until only the lettering is left on the wall.

Step 7:
After the transfer tape has been removed go over each letter to ensure a complete and full bond. Remove any air bubbles, by pressing it toward the edge of the letter. If that does not work, prick the bubble with a needle and press the air out. Enjoy your handy work!